Blomberg Dryer Repair

Blomberg dryer won’t turn on? Control board repair

A dead Blomberg dryer is the most common Blomberg call we get: no lights, no display, buttons not responding, or a dryer that turns itself off. In most cases the cause is the main control board, and the rest of the dryer is fine. We diagnose the power supply, door switch and wiring first, then repair or replace the control board and test the dryer through a full cycle.

A control board repair costs far less than a new compact dryer, and you don’t have to pull a stacked pair out of the closet to replace it. Read more: Blomberg dryer won’t turn on: control board failure and repair.

Blomberg dryer dead? Call 604-729-0499 (8am–8pm daily) or leave a request online.

Other Blomberg dryer problems we fix

• Won’t start, stops mid-cycle or the door isn’t detected. See not starting or not turning.
• Not drying or taking too long, even after cleaning the lint filter. See heat pump dryer not drying.
• No heat or the Drying light flashing on vented models. See not heating.
• Filter or filter drawer warning light that stays on or keeps flashing. See warning lights explained.
• Water problems on heat pump models: tank filling too fast, not draining through the hose, water on the floor. See water tank and drain hose.
• Noise: squealing, thumping or grinding. See noisy Blomberg dryer.
• Clothes come out damp or the sensor ends the cycle too early.

Heat pump and vented Blomberg dryers

We repair both types. Heat pump dryers need a technician who understands the refrigerant side too: our technician holds an ODP certification for refrigerant handling. On vented dryers we also check the vent, because a blocked vent is the most common reason heating parts fail.

Areas we serve

Surrey, Burnaby, New Westminster, Vancouver, Coquitlam, Port Coquitlam, Port Moody, Richmond, Delta, Langley, Maple Ridge, North Vancouver and West Vancouver.