Cove is the dishwasher brand of the Sub-Zero Group, the company behind Sub-Zero and Wolf. Cove dishwashers are fully integrated, very quiet and usually sit behind a custom panel that matches the kitchen cabinets. Because the panel and the cabinet fit are made for that one machine, repairing a Cove is almost always better than replacing it. Doctor Appliance repairs Cove dishwashers from our locations in Burnaby, Surrey and New Westminster, every day from 8 am to 8 pm. The $85 service call is included in the labour when you go ahead with the repair.
$85 service call, included in labour · Google Guaranteed · Licensed & Insured
Cove dishwasher problems we fix
Water left in the bottom. A little water under the filters in the sump is normal on a Cove. Standing water above the filters is not. Cove filters are fine-mesh, so they clog faster than on many dishwashers. Clean the filters first, and if a garbage disposal is connected, run it to clear the drain. If water still stays, we check the drain hose, the check valve and the drain pump. On some models a drain problem shows as error 80 01 40, which Cove describes as the drain pump running too long.
Dishwasher drains all the time and won’t stop. Cove dishwashers have a float in the base pan. When water collects under the tub, the float turns the drain pump on to protect your floor. That means there is a leak inside the machine. We find the source, dry the base and fix the leak.
Stops in the middle of a cycle. Too much detergent, a blocked drain or the wrong water level can stop the cycle. On models with a built-in water softener, a short pause mid-cycle can be normal while the softener regenerates. We check which one it is before changing anything.
Not filling with water. First make sure the shut-off valve under the sink is fully open, especially after plumbing or kitchen work. If it is, we check the water supply line, the inlet valve and the flow meter that measures the fill.
Dishes not clean. Blocked spray arms, clogged filters or a wash pump problem. We clean what can be cleaned and test the pump.
Dishes still wet. We check the drying system and that the dryer vent behind the kickplate isn’t blocked, and we look at the rinse aid setting.
Won’t start, buttons don’t respond. Door latch, control panel or wiring. We test the latch first, because it’s the most common reason a dishwasher refuses to start.
A typical Cove call
A Cove dishwasher behind a custom panel in a New Westminster townhouse in Queens Park: there is water in the bottom after every cycle, and the last load came out dirty. The owner cleaned the outer filter, but the fine filter under it is packed with food. The drain hose also has a kink behind the cabinet where it was pushed back during a kitchen renovation. We clean the filters, straighten and secure the hose, run a full test cycle, and the dishwasher drains completely.
Find your Cove model and serial number
Open the door and look for the rating label on the side of the door frame or on the edge of the tub. Cove dishwasher model numbers start with DW, for example DW2450 or DW2451.
How a Cove repair works
You call 604-729-0499 or send a request, and we confirm a time window. Send a photo of the model label so we can check parts before the visit. The technician diagnoses the appliance on site and tells you what has failed and what the repair will cost before any work starts. If the repair needs the custom panel removed, we take care with the panel and your cabinets. If a part has to be ordered, we tell you how long it will take and come back to install it. Labour warranty up to 1 year; parts carry the manufacturer’s warranty.
Cove repair near you
Burnaby: Burnaby Heights, Brentwood, Deer Lake, Capitol Hill, from our location at 7303 Noble Ln. See dishwasher repair in Burnaby.
Surrey: South Surrey, Morgan Creek, Fleetwood, from 14333 104 Ave.
New Westminster: Queens Park, the Quay, Sapperton, from 140 6th St.
FAQ
Who makes Cove dishwashers? The Sub-Zero Group. We also repair Sub-Zero refrigerators and Wolf ranges and ovens.
Is a little water in the bottom of my Cove normal? Yes, if it stays under the filters in the sump. Water above the filters after a cycle means a drain problem.
Do you need to remove the custom panel? Sometimes, for leaks or for work behind the door. We take care with panels and cabinets.
How much is the service call? $85, included in the labour when the repair goes ahead.
Call 604-729-0499 — 8 am to 8 pm, every day.